0 preparation for paging, Preparation for paging – ADI Systems AT-201 User Manual
Page 43
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
0
Preparation for paging
1) Program an individual code.
2) Program a group code.
NOTE:
A group code must be common for all members of the
group. Both individual and group codes must be a number
of 3 figures.
( Procedure)
Example: To program an individual code 001 for the code
memory address M3 and a group code 100 for M2.
a)
Press the #/PAGE button while pressing the Function button.
b)
The frequency on the display will disappear and be replaced
by "MO COOO”.
c)
Code memory address MO through M3 are used for paging
operation. They are indicated on the display successively by
rotating the channel selector, (the initial display is MO COOO).
d)
Rotate the channel selector for M3 and press numeral
buttons 0,0 and 1. A long beep tone will be generated to
inform you that programming of the individual code is
somplete.
e)
Rotate the channel selector for M2 and press numeral
buttons 1,0 and 0. A long beep tone will be generated to
inform you that programming of the group code is complete.
42