Changing the memory to the 40 channel mode, Programming frequency in memory [*/mr/ent button, Changing the memory to the channel mode – ADI Systems AT-201 User Manual

Page 17: U i- j i i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Changing the memory to the 40 channel mode

This function changes the memory size from 20 to 40

channels. Turn off the radio. Press and hold [CALL] and [6] at

the same time. Turn on the radio.

Note:

“6" is display. Turn radio off, then back on. Normal

display returns. Call channel can not be changed

while in 40 channel mode. If you wish to use the call

channel in 40 channel mode, you must program it

before you put the radio in 40 channel mode.

Programming Frequency in

Memory [*/MR/ENT Button]

Up to 40 memories may be programmed. They are saved

under the addresses 0 through 39 (in 40 channel mode) or 0

through 9 and 0 through 9 (in 20 channel mode).

( Procedure)

(When the memory is vacant)

1. Select VFO mode (no “M” in display)

2. Input frequency, tone, and offset (if needed) and press

[MR/ENT]

3. Select memory 0-9, 0-9, or 0-39 by rotating dial knob.

4. Hold [FUNC] and press [MR/ENT] to store the memory. A

long beep tone notifies you that the operation is complete.

U C D ~i I

I I

b) cl flashing -i ▼

MR/ENT

----------------------------

! I - I . L U

MR/ENT

' ,

L D

r i

I I

/ _ / . L

U ^

remain turned on

^ ,

U C I I I ~ I

I 1

!_/

memory mode

MR/ENT

U I- J I I

L I

dial-frequency