Note – ADI Systems AT-201 User Manual

Page 42

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Automatic Repeater Offset:

1. Select VFO mode (No “M” in display).

2. Press [FUNC]+[2], a+-will be displayed. The proper

repeater + or - offset will now be set by the radio, Repeat

the process to toggle off the automatic repeater offset.

3. The offset frequencies for auto repeater:

• 144.00 to 145.095 MHz : 0 (simplex)

-0.6 KHz

•145.10 to 145.495 MHz

•145.50 to 145.995 MHz

•146.00 to 146.395 MHz

•146.40 to 146.595 MHz

•146.60 to 146.995 MHz

•147.00 to 147.395 MHz

• 147.40 to 147.595 MHz

• 147.60 to 147.995 MHz

0 (simplex)

+0.6 KHz

0 (simplex)

-0.6 KHz

+0.6 KHz

0 (simplex)

-0.6 KHz

23 Exchange the Transmit and

Receive Frequency during
Repeater Operation
[8/REY/TButton]

This feature allows you to exchange the transmit and receive

frequencies during repeater operation. You can check if the

other station is accessible.

(

Procedure)

Set the Transceiver to the repeater mode.

b) Press the 8/REV/T button again while pressing the

Function button or “+” on the display will start flashing

and the transmit and receive frequencies will start flashing

and the transmit and receive or “+” on the display will start

flashing and the transmit and receive frequencies will be

reversed.

Press the 8/REV/V button again while pressing the

Function button or “+” on the display will stop flashing

and remain turned on. The transmit and receive

frequencies will be reversed again and the regular

repeater-mode will be returned.

NOTE:

This feature is only available during repeater operation

and when the transmit frequency is within the operating

frequency range.