ADI Systems AT-201 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(information)
• Press either the */ MR /ENT button or C/VSCAN button to
cancel scanning. The frequency displayed as button is
depressed becomes the operating frequency.
• Be sure that the Transceiver is in the dial-frequency mode
before starting the scan, especially right after the memory
mode is used.
(2) Partial Band Scan
a)
Store scan start frequency into M18(M8 in 20 channel
mode)
b)
Store scan stop frequency into M19(M9 in 20 channel
mode)
c)
Start the 1 MHz band scan operation(see page 23)
d) Press button "6"
e)
The transceiver will enter partial band scan
Note:lf
either M18(M8) or M19(M9) is vacant, then the partial
band scan will become full band scan.
Press button "6" will toggly switch 1 MHz band scan and
partial band scan.
24