ADI Systems AT-201 - Manual (Page 20)

(
Procedure^
a) Set the displayed dial-frequency to 145.16 MHz with the
numeral buttons or the rotary channel selector.
b) Press the */ MR /ENT button while pressing the Function
button. “M” will appear on the display.
c) Press the “1” button for the address number “Ml” The long
beep tone will be generated informing you that the memory
frequency is altered.
d) Press the */ MR /ENT button to return to the dial-frequency
mode when the operation is complete.
e) Please try to change the memory frequency of “Ml” again
to 145.20 MHz
f) In 40 channel mode, memory frequency can only changed
by procedures in page 16.
a) I
I U L, I U
I I ^1. I Li
b) ^ I—
. MR/ENT r* ~
'P i
^ light
iT/ 7.- "i
cl
DUAL
lb I
I I r II
~ i D . I O '
Deleting a Memory Frequency
[*/MR/ENT Button]
Follow the procedure below to delete the programmed
frequency in memory.
( Procedure^
Example:To delete the frequency programmed under “Ml”.
a) Press the */ MR /ENT button. The memory address number
used lastly and concerned frequency will be displayed.
b) Press the */ MR /ENT button while pressing the Function
button. The long beep tone will be generated and “M” on the
display will start flashing. The programmed frequency under
“Ml” is now deleted, (see 2 PROGRAMMING FREQUENCY
IN MEMORY).
c) The dial-frequency will be displayed while the memory mode
is sustained.
d) Press the */ MR /ENT button or C/VSCAN button to release
the memory mode.
e) The Transceiver should be set to the dial-frequency mode
as the operation completed.
19