ADI Systems AT-201 - Manual (Page 38)

NOTE:
(1) “T” and “SQ” will be displayed even though the tone
squelch unit CTS145 is not installed.
TO set the CTCSS (PL) tone frequency:
1. Press [FUNC]+[SET], then [CTCSS].
2. Dial the CTCSS tone frequency.
3. Press [MR/ENTj. To activate the tone; (also see next page.)
4. Press [FUNC]+[+/-/BS] to enable repeater offset.
5. Press [FUNC]+[CTCSS] to turn on CTCSS encode.
20 Special Functions with SET Button
—^[0/SET Button]
Press the 0/SET button while pressing the Function button to
enter the set mode in the set mode, special functions listed in
the table below are available.
NOTE:
(1) A “M” will be indicated on the display when the
Transceiver is in the set mode, However, there are no
indicators on the display for special functions.
(2) Press the */MR/ENT button to return to the
dial-frequency mode. Repeat the same procedures to
release special functions.
Button Special functions in set mode
0/SET Muting the buzzer
1/DUAL Disabled (low beep tone)
2/DUP Disabled (low beep tone)
3/STEP Switching the 100 KHz and 1 MHz channel step
(when the channel selector rolated while pressing
the function button)
4/CTCSS Recalling the tone frecuency
5/SAVE Turning on/off the Auto-Power Off (APO)
6/LOCK Enabling and disabling the rotary channel selector
when frequency lock is tunned on
7/+/-/BS Disabled (low beep tone)
8/REV/T Disabled (low beep tone)
9/SHFTA Disabled (low beep tone)
37