Getting ready, Battery case, Jack cap – ADI Systems AT-201 User Manual
Page 11: Belt clip holder
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GETTING READY
® Battery Case
Depending on what model radio you purchased. The
AT-201 may have come with a 7.2 Volt NiCad. a 12 Volt
NiCad or a battery pack for 6 AA batteries.
© Jack Cap
Cover the jacks with this cap when the external
microphone and external speaker are not in use.
© Belt Clip Holder
The belt clip is fixed to the Transceiver at the factory.
Remove the belt clip when unnecessary and fasten the
screws solely.
1
.
Install the included antenna.
2
■ Detach the battery case
a) Hold the Transceiver and place your thumb on the
Lock button.
b) Push up the Lock Button and pull the battery case as
illustrated to clear the lock.
c) Pull the battery case further and remove it from the
Transceiver.
10