Iv. maintenance - every 6 months, Important notices, Iii. maintenance - every 3 months – Blodgett S1820G User Manual

Page 45

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 4

MAINTENANCE

4, Reattach conveyor guard to control panel and secure
two screws.

Install both upper end plugs.

A. ElectricalTerminals

Open the control cabinet door by removing the three

screws from the control cabinet door. Tighten alt
electrical control terminal screws including the electri
cal contactor and speed control terminal screws as

WARNING

Shut OFF all electrical power and lock/tag outthe

switch before attempting maintenance work.

NOTE:

recommended

that

the

3-month

maintenance be performed by an authorized Blodgett

technician.

Check that the air circulation throughout the oven is not
blocked and is working properly.

IV. MAINTENANCE - EVERY 6 MONTHS

A. Check brushes on D.C. conveyor motor, when worn to

less than 1/8'" (2.4mm), replace the brushes.

B. Check your oven venting system.

C. Inspect and clean the burner nozzle and the spark
electrode assembly.

IMPORTANT NOTICES:

Installation of replacement parts requiring access

to the interior of the oven is permitted only by an

authorized service technician.

If there are any problems with the operation of the
oven, the authorized service technician must be
called.

It is suggested to obtain a service contract with a
manufacturer’s authorized service technician.