Iv. normal operation - step-by-step, Important, Caution – Blodgett S1820G User Manual

Page 30: Normal operation - step-by-step, Conveyor, 5< fiti a

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

IV. NORMAL OPERATION - STEP-BY-STEP

A.Daily Startup Procedure

SECTION 3

OPERATION

1. Check that the circuit breaker/fused disconnect is in the

on position.

Turn

the

"BLOWER/

HEATER" (C03) switch

to the “ON" ("[") posi

tion.

BLOWER/HEATER

Adjust the temperature

controller to a desired set

temperature, if neces
sary.

•

Press the Set Point fi/ti-

and Unlock keys at

the same time. Wait
forthe"SETPT"iight
to turn on.

•

Press the Up Arrow

and Down Arrow
Keys as necessary
to adjust the set-

point.

Q>£

4. Turn the "CONVEYOR"

("i") position, and wait for
the "HEAT ON’Mighttoturn
on.

wait for

Temperature

Display before

Wring switch to

“ON''position.

CONVEYOR

fi-h A V

5. if necessary, adjust the

conveyor speed setting
by pressing the /\or\7
pushbuttons on the con

veyor speed controller to

change

the

displayed

bake time.

6. Wait for the oven to heat to the setpoint temperature.

Higher setpoint temperatures will require a ionger wait.

The oven can reach a temperature of 500°F (232°C) in

approximately 15 minutes.

(Optional)

Press the Tem-

perature (|) key to show

the Actual Temperature

in the display, and wait

for the "ACTUAL TEMP"

light to turn on. This al
lows you to monitor the

oven temperature as it
rises to the setpoint.

^Fsoo

fiti A ▼

wait

for

t ACTUAL
■ THMP

8. Allow the oven to preheat for 10 minutes after it has

reached the set point temperature.

B. DAILYSHUTDOWNPROCEDURE

Turn

the

"BLOWER/

HEATER" (c§j) switch to

the "OFF" ("O") position.

Note that the blowers wiii

remain in operation until

the oven has cooled to
below 200T (93°C).

^ BLOWER/HEATER

2. Make certain that there

are no products left on

the

conveyor

inside

the

oven.

Turn

the

"CONVEYOR"

switch to the "OFF" ("O")

position.

CONVEYOR

3. After the oven has cooled and the blowers have turned

to the “OFF” or“0” position, switch the circuit breaker/fuse

disconnect to the “OFF” or "O" position.

IMPORTANT

On gas ovens. If the "HEAT ON" light will not illuminate,

OR if the oven does not heat, the gas burner may not have

lit. Turn the "CONVEYOR"

and "BLOWER/

HEATER" (C05) switches to the "OFF" ("O") position. Wait

for AT LEAST FIVE MINUTES before restarting the oven.

Then, repeat the Daily Startup procedure.

CAUTION

In case of power failure, turn all switches to the “OFF”

("O") position and remove the product. After the

power has been restored, perform the normal startup

procedure.

IFTHEOVENWASSWiTCHEDOFFFOR

LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE

MINUTES BEFORE RESTARTING THE OVEN.