SINGER 1050 User Manual
Page 78
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing the Bobbin Case
Caution: Before removing the bobbin case disconnect the
power line plug from the socket outlet
Make sure needle is at its highest position.
o
Open slide plate and remove needle plate (see page 7 for
instructions).
e Remove bobbin. Keep bobbin push button in sewing
position.
1. To unlock bobbin case, lift position bracket with the small
screwdriver and slide to right.
2. To remove bobbin case, hold latch, twist to right and lift out.
Replacing the Bobbin Case
Make sure needle is at its highest position.
• Keep bobbin push button in sewing position.
3. Hold bobbin case by latch and, with latch to right of needle,
slip case in position so that the groove engages hook
channel. Twist latch to left until it is in centre.
4. Push position bracket to left until it snaps down, locking
bobbin case in place.
• Replace bobbin and snap latch down.
• Replace needle plate and close slide plate.
77