Threading the machine, Preparation, Step 2 – SINGER 1050 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
threading the machine
Preparation
• Place spool of thread on horizontal spool pin
A.
If spool
being used has a thread retaining slit
B,
it should be placed
against the spool cushion to the right.
• Select correct spool holder according to type and diameter
of spool being used. The diameter of the end of the spool
holder should always be larger than that of the spool itself.
• Press spool holder
C
firmly
against spool.
• Raise the needle and take-up leverto highest position
by turning the hand wheel
toward you.
• Raise the presser foot,
to release thread tension.
Step1
• Snap thread into thread guide post
D.
Step 2
• Thread the rear thread guide E Pass thread under
flange, then over to the far right end of cylinder.
16
- 401A (116 pages)
- Simple 3116 (94 pages)
- 1507WC (88 pages)
- 1507 (88 pages)
- 112W140 (32 pages)
- 147-2 (30 pages)
- 114-33 (43 pages)
- 119-3 (23 pages)
- 14K1 (10 pages)
- 147-104 (34 pages)
- 116-1 (20 pages)
- 115-2 (38 pages)
- 14U286 (40 pages)
- 14U286B (21 pages)
- 114-4 (29 pages)
- 142W25 (10 pages)
- 147-81 (28 pages)
- 118 (16 pages)
- 136W105 (22 pages)
- 114-41 (20 pages)
- 147-4 (28 pages)
- 105-3 (30 pages)
- 1027 (36 pages)
- 147-26 (37 pages)
- 12W208 (25 pages)
- 128-4 (25 pages)
- 109-320 (14 pages)
- CP17 (47 pages)
- 147-6 (56 pages)
- 132B26 (9 pages)
- 114-2 (36 pages)
- 1371A3 (86 pages)
- 14CG754 (53 pages)
- 147-50 (39 pages)
- 14T967DC (3 pages)
- 109-520 (13 pages)
- 14SH654 ULTRALOCK (48 pages)
- 147-86 (30 pages)
- 105-20 (23 pages)
- W303 (13 pages)
- 147-38 (53 pages)
- 114-22 (45 pages)
- 1375A1 (33 pages)
- 107-2 (31 pages)
- 1200A (4 pages)