Removing and changing the bobbin, Using previously wound bobbin, Removing and replacing – SINGER 1050 User Manual

Page 23: The bobbin case

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Removing and Changing the Bobbin

f there isafull bobbin in the machine and you wish to change it:

1. Raise needle and take-up lever to highest position by

turning hand wheel

toward you.

Open slide plate. Raise

bobbin latch by inserting tinger under end ot latch at centre

ot bobbin.

2. Insert tinger under rim ot bobbin immediately to right ot latch

and remove bobbin.

3. Check empty bobbin tirst to

ensure that both halves are

tightened securely

as described on page 23, Removing

Thread trom Bobbin. With latch raised, slide bobbin with
circle side up into bobbin case.

4. Snap latch down to secure bobbin,
e Wind the bobbin. See page 21.

Using Previously Wound Bobbin

A tull bobbin is inserted in the same manner as an empty one.

5. Place bobbin into case with at least 10cm (4 inches) otthread

leading ottto right side ot latch. Allow the thread to lay in the
slot in the slide plate when closed.