Curved seams, Reinforcing end of seam, Reinforcing end of seams – SINGER 1050 User Manual

Page 33

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Curved Seams

• Use a short stitch for elasticity and strength. For example,

if the stitch length control on your machine is set on 2

for straight seams, adjust the control between 1.5 to 2 to
stitch curved seams in the same fabric.

• If you use the seam guide, attach it at an angle so that the

edge that is closer to the needle acts as a guide.

Reinforcing End of Seam

• stitch to the edge of the fabric. (Do not sew beyond edge

of fabric)

• Press reverse stitch button and hold in place. Backstitch

approximately 1.5 cm (’/2 inch) to reinforce end of seam.
Release reverse stitch button.

• Raise needle and take-up lever to highest position by

turning hand wheel

toward you

and raise presser foot.

Remove the fabric by drawing it to the back and left.

• Cut threads on thread cutter at rear of presser bar.

! +

:i'

^ III