Raising the lower thread, Removing thread from bobbin – SINGER 1050 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Raising the Lower Thread

1. Hold upper thread lightly

with left hand and turn hand
wheel slowly

toward you so

the needle enters plate.

2.,

Continue turning hand

wheel and holding upper
thread until needle rises.
Tighten your hold on the

upper thread and bring up
lower thread in a loop.

3. Open the loop with your

fingers, draw approximately

10 cm (4 inches) of both
upper and lower threads
under the presser foot and
place them diagonally to
left.

Removing Thread from Bobbin

1. If there is not much thread left on the bobbin in the

machine, simply pull the thread end through the
needle plate until bobbin is empty.

If there is a lot of thread on the bobbin, remove bobbin,
unscrew the two halves of the bobbin and remove all

the thread. Then tighten bobbin halves securely.