SINGER 1050 - Manual (Page 43)

Appliqué
The stitch most commonly used in appliqué is a plain zig-zag,
closely spaced to form a satin stitch. The width of this stitch
can be varied to accommodate fabrics of different weaves and
textures. Other stitch patterns can also be used.
Preparation
Make a test sample to decide which of the following methods
is the most appropriate for your fabric and design. Mark design
on piece of fabric to be appliqued. Cut out design leaving
about 2 cm pA inch) margin all around.
Position the design.
Baste it to the fabric.
Method 1
® Set pattern selector and stitch width dial for desired
applique stitch. Adjust stitch length to fine setting, between
1 and 0.
• Follow the outer edge of the design with a decorative stitch.
• Trim away the excess fabric on the outer edges of the
stitching.
Method 2
® Select straight stitch.
• Outline the entire design with a short stitch.
• Trim raw edges to the stitching and remove basting.
• Selecht stitch pattern and stitch width desired, and set stitch
length on a satin stitch setting for a closely spaced stitch,
between 1 and 0.
® Stitch, following the straight stitch outline. This method will
produce a smooth overedged finish, with no raw edges to
be trimmed after stitching.
Method 3
® Purchased motifs can be appliqued quickly and easily by
using either a straight or decorative stitch.
42