USL JSD-100 Manual User Manual
Page 19
19
USB Driver Removal
To remove the previous JSD‐100 USB driver installation, the JSD‐100 must be connected to the computer and by
using Device Manager, the driver will be
uninstalled using the following steps below:
Power on the JSD‐100 and when startup is
complete, connect the USB cable to the
computer.
Run device manager and locate the “LibUsb
Devices” entry and select the USL JSD‐100
Cinema Processor.
Right click the mouse to open the
properties dialog and then activate the
“Uninstall” button.
On Windows 7, check the delete option,
and then proceed by activating the “OK”
button.
Unplug the USB cable and proceed to driver
installation.
USB Driver Installation
The JSD‐100 Installation (Setup) program creates a
subfolder called “WinUSB_Drivers” that will be
used for loading the new WinUSB driver.
Start device manager and then connect the
USB cable to a powered on JSD‐100.
Select the USL JSD‐100 Cinema Processor from
the device list and right click and select
“Properties.”
Use the “Browse my Computer for the driver
software” option to load the WinUSB driver.
Note that the search automatically option will reload the old version and will need to repeat the driver
removal process.
Browse to “C:\Program Files\USL\JSD‐100\WinUSB_Drivers” and then proceed to load the selected driver by
activation of the Next button.
Proceed to load the selected driver by selecting the “Install this driver software anyway.”
When the installation completes, the device manager will now display the USL JSD‐100 Cinema Processor
under the libusb (WinUSB) devices. From the GUI the JSD USB device will appear in the Communications
Settings dialog.