USL CMS-2200 Quickstart - Manual

CMS‐2200 Quick Start Guide
Physical Installation
1. Remove the front panel of your projector and prepare ESD protection.
2. Insert the CMS‐2200 into the IMB slot of a series 2 projector.
3. Fully seat the CMS and secure the 2 included screws on the left and right side of the faceplate.
4. Reassemble the projector front panel.
5. Attach Cat. 5 AES audio cables from the CH 1‐8 and CH 9‐16 AUDIO OUTPUT ports to your sound processor.
6. Attach network cables to the AUX and DATA INPUT B ports if using secondary networks. Closed Captioning will
be played via the AUX port. *Do not connect the AUTOMATION port to a network.
7. Connect the AUTOMATION GPIO port to a CMSA with a Cat. 5 cable. The GPIO pinout is below.
8. Power the projector and perform the marriage procedure.
IP address setup
1. Open the web tool. Use a web to go to:
http://ip_of_projector:43758/cgi‐bin/pycgi.py
2. Select “Edit Network Port Configuration”
for Action. Enter login information from
the next page and press “Send
Command”.
3. In the form that loads, enter the IP and
type of projector in the first section, set
the network configuration for the AUX
port in the second section, and the DATA
B port in the 3
rd section.
4. Save these settings by pressing the
“Update System Configuration” button at
the bottom of the page.
A reboot of the projector is recommended
after changing these settings.
Pg 1