Tuffy Security 280 - Manual (Page 5)

Page 5 of 5 – 06/23/2011 – Rev6/23/2011
7. It is most convenient to set the combination lock code at this time. Refer to the document titled “089 Operating
instructions” for instructions on setting combination code. The combination pushbutton lock is typically shipped
from the factory with either no code entered yet or “12345” and will need to be reset by the customer.
**DO NOT CLOSE THE DRAWER AT THIS TIME. Test the operation and function of the combination lock and the
original pushbutton lock before closing the drawer.
8. Test the combination lock and the original pushbutton lock by closing, unlocking and reopening the drawer. Refer to
the document titled “089 Operating instructions” for instructions on operating the combination lock.
9. Finally, re-install the #13 Drawer Front Latch Cover into position and fasten with the (2) #17.1 screws and (2) #17.2
nuts on each side followed by the (4) #17.4 screws and (4) #17.3 nuts at the drawer front. (Figure 7)
FIGURE 7
ATTENTION:
FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM
The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this mechanism is not
lubricated regularly it will become difficult to operate and it may not return to its home position preventing the key from
operating the lock. If this happens simply pull up on the pushbutton to manually bring it back to its home position.
Lubricate the pushbutton with a light lubricant such as silicone spray. The pushbutton may have to be periodically
disassembled and cleaned.
Call (970) 564-1762 for Technical Support