Tuffy Security 280 - Manual (Page 3)

Page 3 of 5 – 06/23/2011 – Rev6/23/2011
3. Remove the #20.2.3 Standard Latch assembly by removing the (2) 20.3.2 carriage bolts, (2) 20.3.6 rubber washers,
(2) #20.3.3 washers, and (2) #20.3.4 nuts. Save all hardware for reuse. (Figure 3)
FIGURE 3
4. Install the #20.4.6 Combination Lock Assembly through the pre-manufactured holes in the #9 Drawer Front. Fasten
the combo lock to the drawer front with the (4) #20.4.14 screws. Install the #20.4.9 Stop Washer and the #20.4.10
Combo Cam onto the combination lock assembly shaft. Fasten with the (1) #20.4.16 washer and (1) #20.4.15 screw.
(Figure 4)
**NOTE THE POSITION AND ORIENTATION OF THE STOP WASHER AND COMBO CAM IN FIGURE 4. BOTH
MUST BE INSTALLED CORRECTLY ONTO THE SHAFT IN ORDER FOR THE COMBINATION TO FUNCTION
PROPERLY.
FIGURE 4