Tuffy Security 280 - Manual (Page 4)

Page 4 of 5 – 06/23/2011 – Rev6/23/2011
5. Install the #20.4.5 Combo Latch Assembly onto the drawer front panel by fitting it over the pushbutton and combo
locks. **This is performed on the inside face of the drawer. Fasten the assembly to the drawer front with the (2)
#20.3.2 carriage bolts, (2) #20.3.6 rubber washer, (2) #20.3.3 washers, and (2) #20.3.4 nuts (removed in Step 3).
(Figure 5)
FIGURE 5
6. Install the #20.4.7 Combo Lock Drawer Handle to the front of the drawer and install with the (4) #20.3.2 carriage bolts,
(4) #20.3.3 washers, and (4) #20.3.4 nuts (removed in Step 2). (Figure 6) **NOTE THE ORIENTATION OF THE
HANDLE FITS OVER THE COMBO LOCK AND ORIGINAL PUSHBUTTON LOCK IN ONLY ONE WAY.
FIGURE 6