Tuffy Security 280 - Manual

Page 1 of 5 – 06/23/2011 – Rev6/23/2011
INSTALLATION INSTRUCTIONS
#280 Combo Lock Kit for #167, #171, or #258
(This kit is designed to install on a rear cargo/tactical drawer sold separately.
Rear cargo drawer must be pre-manufactured to accept this kit.)
Attention: For instructions on setting the combination, search “089 - COMBINATION LOCK FOR CAMLOCK
SYSTEM” at tuffyproducts.com and click on the link to the pdf “Operating instructions - setting the combination”
280 Parts Checklist
#20.4.7 (1) Combo
Lock Drawer Handle #20.4.6 (1) 089
Combination Lock
Assembly #20.4.5 (1) Combo
Latch Assembly #20.4.10 (1) Combo
Cam #20.4.9 (1) Combo
Stop Washer
280 Shipping Package
#20.4.15 (1) #10-24 x ¼”
Cam screw #20.4.16 (1) #10 washer #20.4.14 (4) #6-32 x 5/16”
Torx screw
Parts used from the drawer shipping package (Included with drawer)
#20.3.2 (6) 5/16-18x7/8”
Carriage Bolts #20.3.3 (6) 5/16 Washers #20.3.4 (6) 5/16 Nuts #20.3.6 (2) 5/16” Rubber
Washers
#17.1 (2) #8-32 x 1/2”
Philips flat head screws #17.2 (2) #8-32 Nuts #17.4 (4) #10-32 x ½” Hex
washer screw #17.3 (4) #10-32 Flange
nuts
Tools required
•
½” socket and a ratchet
•
½” Wrench
•
5/16” socket and ratchet or 5/16” wrench
•
Philips or Flat screwdriver
•
T-15 Torx bit or screwdriver
Installation Directions
REMOVAL OF THE DRAWER FROM THE ENCLOSURE IS NOT REQUIRED TO PERFORM THIS INSTALLATION. IF
THE DRAWER IS TO BE REMOVED, FOR SAFETY THE DRAWER REMOVAL REQUIRES AT LEAST (2) PEOPLE.
THE DRAWER SHOULD ALWAYS BE EMPTY BEFORE REMOVING IT. CONSTANT SUPPORT MUST BE APPLIED
TO HOLD UP THE FRONT OF THE DRAWER THROUGHOUT THE ENTIRE REMOVAL PROCESS SO IT DOES NOT
CAUSE INJURY AND/OR DAMAGE.