Tuffy Security 286 - Manual (Page 6)

Page 6 of 7 – 8/8/2014 – Rev A
14. Install the #1 Lid with trim pieces into the vehicle by positioning the rear side flanges under the hardtop mounting lip at
the rear of the vehicle body and tilting the Lid downwards to meet up with the #2 Front Panel. The #1 Lid is intended
to lap over the front of the #2 Front Panel. For a cleaner installation, be sure the #1 Lid front flange tucks inside the
#6.6 rubber edge trim pieces on the #2 Front Panel (if applicable). (Figure 3)
**Note: Be sure to keep the #6.8 rubber edge trim in position when installing the #1 Lid in order to insure a proper
seal between the Lid and the roll bar.
***Note: If installing the #286 Tailgate Security Enclosure on a vehicle with a softtop, it will be easier to remove the (2)
softtop rear window bar clips located to either side of the tailgate. Once the #1 Lid is properly installed, the clips can
be re-installed by pressing the lid downwards and clipping the clips under the body lip.
FIGURE 3
15. Install (2) #6.1 carriage bolts from the front of the installed enclosure. Install (2) #6.2 washers and the (2) #6.3 wing
knob nuts from inside the enclosure. The two panels have slotted mounting holes to allow for the tailoring of the
enclosure fit and position – it may be necessary to raise or lower the #1 Lid a small amount. (Figure 4)
FIGURE 4