Tuffy Security 286 - Manual (Page 4)

Page 4 of 7 – 8/8/2014 – Rev A
INSTALLATIONS IN A 4-DOOR WITHOUT OEM SUB-WOOFER
9. Loosely assembly the #2 Front Panel, #3 Front Panel Extension, #4 Left Mounting Bracket, and #5 Right Mounting
Bracket using the supplied #6.1 bolts, #6.2 washers, and #6.4 nuts, as illustrated. Leave all fasteners hand tight at
the point. Place the assembled parts in the vehicle. Align the #2 Front Panel approximately ½” forward of the seam
in the #9.2 OEM Rear Storage Cover. **Note the bottom bolt flange on the #4 and #5 Mounting Brackets may need to
be bent inboard away from the fender wells to allow the #2 Front Panel to sit flush to the cargo floor. **Note: The #3
Front Panel Extension is installed to the rear side of the #2 Front Panel. (Figure 1c)
FIGURE 1c