TeeJet Fieldware Tool - Manual (Page 25)

21
Fieldware
®
Tools
98-05048 R3
Running the Product Wizard
Select the type of application you are doing
(Figure 23). Press the Green forward to move to the
next wizard page.
Figure 23: Product Wizard Application Type
Next select the number of products used in the
application (Figure 24).
Figure 24: Product Wizard Number of Products
Select the Product Name (Figure 25). This is the list of
products found in the Product Profile. You can press
the NEW button to go directly to the Profile Builder.
From there you can add or edit a product.
Figure 25: Product Wizard Product Name
Once the product name has been selected, press the
Green arrow and select the Product Unit (Figure 26).
Figure 26: Product Wizard Product Unit
Next enter the Product Application Rate, Total Amount
of product applied, or both (Figure 27)
Figure 27: Product Wizard Application Rate
If you have selected more than one product, the
Product Wizard cycles back through Product Name,
Unit, and Application Rate until all products are
identified. After all product information is entered,
the next Wizard page is based on the Application
Type selected in the first Wizard page (Figure 23).
In this example a Liquid (Wet) product was selected.
Therefore the next Wizard page is Water Unit (Figure
28). If a dry application type was selected the water
(carrier) Wizard pages would not appear.
Figure 28: Product Wizard Water Unit