TeeJet IC18 SPRAYER JOB COMPUTER - Manual (Page 52)

46
www.teejet.com
ISOBUS Job Computer : IC18 Sprayer
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Section and Icon Descriptions
Section or Icon Description
Job Information This information bar displays the active count number,
applied volume and applied area
C n t 1 0 g a l 0 . 0 0 a c
Count Number Displays the current active trip or job number
Applied Volume Displays volume applied for the selected count number
Applied Area Displays applied area for the selected count number
Speed/Application
Information
Displays vehicle speed or volume applied per minute or projected area per hour to
be covered or projected total area remaining to be covered depending upon which
view is active.
The Information Key toggles between display modes.
Remaining Tank
Contents
Displays the remaining tank content
NOTE: If no tank sensor is fitted or the contents are not entered in the
Tank Filling Menu prior to spraying, Tank Contents may not
display the correct amount.
Application Rate Displays the actual application rate per hectare/acre
NOTE: When the Master is “On” the actual application rate per hectare/acre will
be displayed. When the Master is “Off” the target rate is displayed and the
TARGET RATE ICON appears
Target Rate
Percentage
Increase/
Decrease
Displays boost percentage step, i.e. the step size, at which the
application rate is to increase/decrease with the boost function
Alarm Displayed if an alarm condition is active
Flow Based or Pressure
Based Icons
These symbols will only appear if both a flow sensor and a pressure sensor are
installed.
Flow Based - displayed if a regulation is based on flow
Pressure Based - displayed if regulation is based on pressure.
Density
D
Displays a “D” to the left of the tank icon if the density is set to “Fertilizer” instead of
water.