TeeJet IC18 SPRAYER JOB COMPUTER - Manual (Page 34)

28
www.teejet.com
ISOBUS Job Computer : IC18 Sprayer
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
Low Pressure Limit
Low Pressure Limit establishes the limit for the lowest allowed operating pressure for the selected nozzle type.
• To select the Low Pressure Limit, use the number pad or slide bar.
High Pressure Limit
Figure 3-21: Recommended Pressure Range bar and
High Pressure Limit on the Operating
Screen
High Pressure Limit establishes the limit for the highest
allowed operating pressure for the selected nozzle type.
• To select the High Pressure Limit, use the number
pad or slide bar.
Reference Flow
Reference Flow establishes the value for the volume
applied over a specific time (GPM or LPM).
• To select the Reference Flow, use the number pad or
slide bar.
Reference Pressure
Reference Pressure establishes the pressure value at
which the application rate is true (ISO=2 bar).
• To select the Reference Pressure, use the number
pad or slide bar.
IMPORTANT! Always refer to the nozzle pressure values
recommended by the supplier when setting the
nozzle pressure.
Factory Settings
Figure 3-22: Confirm Factory Settings
Factory Settings resets all nozzle settings to the default
settings for the selected nozzle size and type.
• To reset the Factory Settings, select FACTORY
SETTINGS KEY . A confirmation screen will be
displayed.