TeeJet IC18 SPRAYER JOB COMPUTER - Manual (Page 29)

23
98-05204 R1 US
ISOBUS Job Computer : IC18 Sprayer
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
MACHINE
Machine configures machine settings. Options include Filling, Operation, Implement Parameters, Calibrations,
Alarm Configurations and OEM.
MAIN SETUP MODE MENU STRUCTURE
| | | | | |
Counters Job Parameters Machine User Interface Communication Help
Filling
Operation
Implement parameters – Section width
Implement speed sensor – Calibrations Nozzle preset setup
Flow sensor Alarm configurations Regulation parameters
OEM
The OEM setup menu is password protected and the settings in this menu are directly related to the fitted OEM equipment.
Figure 3-13: Machine
1. From the Main Setup Screen , select MACHINE.
2. Select from:
►Filling – establishes the amount of material
remaining in the tank and the density of that
material.
►Operation – establishes Application Rate Step,
Speed Source, and Simulated Speed.
►Implement Parameters – establishes the Section
Width, Nozzle Preset Setup and Regulation
Parameters.
►Calibrations – establishes either manual or
automatic settings of the sensors.
►Alarm Configurations – establishes alarms for CAN
Speed Source Timeout, Active Trip Count Information mode and Tank Content Minimum
►OEM – The OEM setup menu is password protected and the settings in this menu are directly related to the
fitted OEM equipment. Refer to the OEM Manual for information regarding OEM settings.
NOTE: Settings are NOT automatically saved when selected. The ACCEPT KEY must be selected to save
the setting. Select the ESCAPE KEY to escape without saving settings and return to the previous
menu.