Carrier Access Access Bank II SNMP - Manual (Page 26)

About This Chapter
9/24/01 2-1
Chapter 2
Product Description
Contents of This Chapter:
2.1 About This Chapter
This chapter describes the general physical characteristics and layout of the Access Bank II - SNMP,
including its:
• Dual RJ-48C Jacks for T1 Span 1 and Span 2
• V.35 and RS-232 Digital Interface Ports
• Power Source Connector
• Standard 25-pair RJ-21X Tip & Ring Telephony Connector
• T1 Span and System Setup DIP switches
• LED Test and Status Indicators
2.2 Physical Characteristics
The Access Bank II - SNMP consists of a painted sheet steel chassis housing, nickel-plated chassis
tray and removable back plate that accepts one (or two) 7.8 inch by 13.16 inch analog line interface
daughter card(s). These analog line interface channel cards slide into the rear of the unit along rails
that guide a 64-pin DIN connector on each card to mate with a matching connector on an internal
About This Chapter .................................... 1
Physical Characteristics ............................. 1
Control Panel Interface Connectors ........... 2
Control Panel DIP Switches ....................... 3
LED Test and Status Indicators ................. 3