Carrier Access Access Bank II SNMP - Manual (Page 146)

About This Chapter
9/24/01 14-1
Chapter 14
SNMP Management &
Command Line Interface
Contents of This Chapter:
14.1 About This Chapter
This chapter provides a general introduction to Carrier Access Corporation’s Access Bank II SNMP
and includes summaries of its:
• Simple Network Management Protocol (SNMP) Management
• Command Line Interface (CLI) Management
14.2 Local/Remote Mode Selection
The Access Bank II SNMP comes equipped with two sets of external DIP switches for selecting local
or remote control. The DIP switches must be set to the remote software control mode in order to use
SNMP, CLI, or GUI management terminals.
In the local hardware control mode, you can use these DIP switches to perform self-tests for channel
alignment, to select basic T1 hardware configuration parameters (AMI/B8ZS, D4/ESF), and to
enable detection of standard D4/ESF inband loop codes by the integral CSUs.
About This Chapter .................................... 1
Local/Remote Mode Selection ................... 1
SNMP Management .................................. 2
Command Line Interface (CLI) .................. 7
Context Sensitive Help .............................. 9
Configuration Commands ........................ 19
Status Commands ................................... 29