Carrier Access Access Bank II SNMP - Manual (Page 171)

14-26 9/24/01
14.4.4.23 rs232
Use the rs232 command to configure the RS232 port. To see all the options for this command, type
rs232 help .
14.4.4.24 screen height
Use the screen height command to set or display the current display parameters.
14.4.4.25 snmp
Use the snmp command to configure the SNMP system group settings. To see all the options for this
command, type
snmp help .
14.4.4.26 telnet
Use the telnet command to configure the echo for the telnet sesson. The echo can be turned on and
off.
14.4.4.27 time
Use the time command to set time in the format shown: The time is used to accurately time stamp
Operations Type Comments
To validate that a node
on the network can be
reach via the Access
Bank II - SNMP ping 192.127.20.10 Sends one Ping to the indicated ipaddr
To send IP ping 4 times
with 50 ml delay
between pings ping 192.127.20.10 4 50 Sends 4 Pings to the indicated ipaddr
with 50 ms delay between pings
To display Help ping?
Operations Type Comments
To display current screen
parameters screen height