Carrier Access Access Bank II SNMP - Manual (Page 155)

14-10 9/24/01
2. Type help at the prompt to list all of the commands and options, as shown below.
Commands ............. Command LineInterface Help. Forimmediate
context sensitive help, type ? at any
time.
For full command help, type “help” after
any partial command.
\ ................. Enter \ to go to the top command level
aco ................. Display/Set Alarm Cutoff
off ................ Disable alarm
on ................. Enable alarm
alarms ............... Display/Set current alarms
all on|off ......... Set all alarms
sys ................ Display/Set system alarms
power on|off .. Hard reset or power on detected
brownout on|off .. Brown out detected
reset on|off .. Soft reset detected
vn ................. Display/Set alarms for V.35 #n
rts on|off .. Loss of V.35 RTS
llb on|off .. Local Loop Back detected
v54 on|off .. Remote V.54 Loop Back detected
dn ................. Display/Set alarms for ds1 #n
carrier on|off .. Loss of carrier detected
csuloop on|off .. CSU loop code received
unframed on|off .. Unframed, all 1’s received
sync on|off .. Loss of sync
yellow on|off .. Yellow alarm received
bpv on|off .. BPVs exceed 1544 in 15 min period
ses on|off .. SES exceed 10 in 15 min period
unavail on|off .. Unavailable seconds in 15 min period
fdlline on|off .. FDL line loop request received
fdlpay on|off .. FDL payload loop request received
aps ................. Display/Set Automatic Protection Switching
off ................ Disable APS mode
primary dn ......... Set either d1 or d2 as primary span
threshold n ........ Set BPV switch threshold to 10^-n, 4<=n<=6
boot ................. (Re)Boot the system... all connections
will be dropped during initialization
clk ................. Display/Set T1 Clock
primary ............ Set T1 Primary Clock Source
t11 .............. Set Clock Source to T1 #1
t12 .............. Set Clock Source to T1 #2
internal ......... Set Clock Source to internal
secondary .......... Set T1 Secondary Clock Source