Carrier Access Access Bank II SNMP - Manual (Page 168)

Command Line Interface (CLI)
9/24/01 14-23
14.4.4.13 event
Use the event command to display or clear the event log.
14.4.4.14 exit
Use the exit command to end the current management session.
14.4.4.15 ip
Use the ip command to set and display the ip addresses for an SNMP management session This com-
mand is used to configure the system for SNMP and Telnet access.
Operations Type Comments
To display the next 18
events
event
To display the entire
event log event all
To display the first 18
events event first
To clear the event log event clear
Operations Type Comments
To end current session exit Ends current session
Operations Type Comments
To configure the Access
Bank SNMP parameters ip addr 192.168.0.220 Configures the IP address
To verify configuration
using the show command ip Displays all current IP related
parameters.
To show Help ip ?