Carrier Access Access Bank II SNMP - Manual (Page 164)

Command Line Interface (CLI)
9/24/01 14-19
14.4.4.2 alarms
Use the alarms command to turn on and off, the Access Bank alarms.
14.4.4.3 aps
Use the aps command to set or display the status of the Automatic Protection Switching.
14.4.4.4 boot
Use the boot command to reboot the system. All calls and connections are dropped during the reboot.
Operations Type Comments
To turn the Alarm Cutoff
on aco on
To turn the Alarm Cutoff
off aco off
To display the status of
the Alarm Cutoff aco
Operations Type Comments
To set all alarms on alarms all on
To set all alarms off alarms all off
To set a specific alarm on
or off alarm
[sys|vn|dn][alarm]on|off To see all options for alarms, type
alarm help
To display alarms alarms
Operations Type Comments
To set either d1 or d2 as
the primary span aps primary dn
To set BPV switch
threshold to 10^-n,
4<=n<=6 aps threshold n
To display APS status aps