Conair 100 - Manual (Page 37)

3
Description
I n s t a l l a t i o n l 3 - 1 5
C o n n e c t i n g t h e A i r H o s e s
Using the two flexible hoses provided, connect the inlets and outlets of the dry-
ing hopper to the dryer. If you have positioned the dryer on the floor or mount-
ed it to an optional floor stand, make sure the dryer is located no more than 5
feet (1.5 m) from the hopper to reduce heat loss.
If you ordered an insulated hose, it should be installed between the dryer outlet
and the hopper inlet.
If you have ordered an optional
aftercooler or precooler, see
Appendices C
and E.
1 Attach the hose to the return
air outlet at the top of the
hopper labeled “From Hopper”.
2 Attach the hose to the hopper’s
delivery air inlet labeled “To
Hopper”.
3
Secure hoses with clamps.
The hose clamp should be secured at
least 1/4 in. (0.64 cm) from the end of
the inlet or outlet tube.
C o n n e c t i n g t h e W a t e r H o s e s
The optional aftercooler, flow control, and precooler require a source of cooling
water and a discharge or return line. See Appendix C for information on installing
and connecting water hoses to the optional aftercooler. See Appendix D for infor-
mation on installing and connecting water hoses to the optional flow control. See
Appendix E for information on installing and connecting water hoses to the option-
al precooler.
NOTE: Do not allow the
flexible hoses to kink or
crimp.
✐
Delivery air
outlet (75 and
100 models)
Return
Air Inlet
Delivery air outlet
(15, 25, and 50
models)
Return
Air Inlet