Philips VRA456AT - Manual (Page 9)

Hookups with a Cable Box/Direct Broadcast System (confd) 9
With this connection:
^ You may watch one channel while recording another.
^ You may not record scrambled channels.
TV’s
ANTENNA
IN jack
Connections
Connect a Cable signal to the VCR’s ANT(enna) IN jack.
2
Use an RF coaxial cable (supplied) to connect the RF OUT jack on
the VCR to the IN jack on the Cable Box/DBS.
3
Use a second RF coaxial cable to connect the OUT jack on the
Cable Box/DBS to the TV’s ANTENNA IN jack.
Recording One Channel/Watching Another
I
Put the Cable Box/DBS on the same channel as the VCR’s
CH3/CH4 switch. Set the TV to the Cable Box/DBS output chan-
nel^(03 or 04).
Then, with the VCR in VCR position (the VCR light will appear on
the display panel), use the CH(annel) A/T button to select the
channel you want to record at the VCR. Start the recording.
2
Press theVCR/TV button once to put the VCR in TV position.
(The VCR light will disappear.)
3
Select the channel you want to watch at the Cable Box/DBS.
Helpful Hint
When you play a tape, make sure
the Cable Box/DBS is set to the
same channel as the CH3/CH4
switch on the VCR. Set the TV to the
Cable Box/DBS output channel (03
or 04).