Press the vcr button, O (q) 0, One-touch recording – Philips VRA456AT User Manual
Page 30: Qdrcdtgd
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
30
One-Touch Recording
The One-Touch Recording (OTR) function allows you to start an
immediate timed recording 30 minutes to six hours long of the
channel you are watching. Before you begin, make sure:
^ Channels are set up. Details are on pages 11-12.
^
The desired recording speed (SP or SLP) has been selected with
the SPEED button. Details are on pages 37 and 52.
® There is a tape in the VCR. Make sure the tape’s record tab is
intact (see page 5) and the tape is long enough to record the
program(s). If the end of the tape is reached during an OTR,
recording will stop.The VCR will eject the tape and turn itself
off.
^ The VCR is in VCR position. (The VCR light will appear on the
display panel of the VCR when the VCR is in VCR position. If the
VCR light does not appear, press the VCR/TV button once.)
Starting an OTR
O (Q) 0
VCR/rV POWER EJECT
O O 0
.----— QUICK PROGRAMMING —--.
QDrCDtGD
Press the VCR button.
Use the CH(annel)
A/T
button or the Number buttons to
select the channel you want to record.
3
Press the REC(ord)/OTR button repeatedly until the
desired recording length appears briefly on the screen and
on the display panel. The
O
light will flash on the display panel.
(The recording length will not appear on the screen if ON
SCREEN MODE is set to OFF)
OTR (0:30)
4
To stop an OTR before recording is finished, press the STOP
V
button.
To cancel the OTR but continue recording, press the
REC(ord)/OTR button repeatedly until REC appears in the upper
left corner of the TV screen. (ON SCREEN MODE cannot be set
to OFF. Details are on page 25.)
The
O
light will remain on the dis
play panel.
Helpful Hints
I
to check the time remaining for on
OTR after the OTR is in progress,
press the EXIT/STATUS button. The
remaining time will appear on the
screen. (The recording length will not
appear on the screen if ON
SCREEN MODE is set to OFE)
To change the recording length while
an OTR is in progress, press the
REC(ord)/OTR button until the
desired length appears on the VCR
display panel. The desired length
also will appear on the screen if ON
SCREEN MODE is set to ON or
COUNTER.
If the preset time for a timer record
ing comes up during an OTR, the
OTR has priority.