Philips VRA456AT - Manual (Page 10)

10 Turning on Your VCR
Before turning on yourVCR, make sure batteries are in the
remote control and the VCR,TV, and Cable Box/DBS (if applicable)
are connected.
1
*r<
2
Press the VCR button, then press the POWER button.
Turn on the TV. Set it to channel 3 or 4, whichever chan­
nel the CH3/CH4 switch on the back of the VCR is set to.
The menu shown below will appear.
^SELECT A V
^ ENGLISH
ESPAÑOL
FRANÇAIS
MAKE SELECTION OR
PUSH WOK TO CONTINUE
3
Press the PLAY A or STOP ▼ button to select the lan­
guage of the on-screen displays and menus.
4
Press the FF ►/OK button. The menu shown below will appear.
CONNECT ANTENNA OR CABLE
TO VCR
THEN PUSH WOK KEY
OR...
FOR PLAY ONLY - PUSH STOP
5
Press the FF ►/OK button to begin automatic channel
setup. AUTO CH. SET PROCEEDING PLEASE WAIT will appear
on the screen.The VCR will memorize all of the channels you
receive, so when you scan through channels using the CH(annel)
A/y button, you’ll only scan through channels that you receive.
6
When channels are set up, AUTO CH. SET COMPLETED will
appear on the screen briefly.
2
6 Turn on the TV.
Wait for the VCR to set up
channels.
Helpful Hints
Auto or — : — may appear on
the display panel until the clock is
set
If you do not want to set up chan­
nels now, press the STOP
V button
at step 5. TUNER NOT SET will
appear on the screen briefly.
You may not set up channels at
step 5 if you are using a Cable
Box/DBS.