Philips VRA456AT - Manual (Page 36)

36 Quick Programming
Follow the steps below to program your VCR to record TV pro­
grams while you’re away from home.The VCR will turn itself on,
record, and turn itself off automatically.
Before you begin make sure:
^ Channels are programmed.
Details are on pages 11-12.
* The clock is set. Details are on pages 13-17. If the clock is not set,
CLOCK MUST BE SET appears on the screen, followed by the
menu.
* There is a tape in the VCR. Make sure the tape’s record tab is
intact and the tape is long enough to record the program(s).
® The VCR is in VCR position.The VCR light will appear on the dis­
play panel when the VCR is in VCR position. If the VCR light does
not appear, press the VCR/TV button once.
® When you use a Cable Box/DBS, timer recordings are pro­
grammed differently. Read pages 8-9 before proceeding.
Complete each step within 60 seconds of the previous step.
I
I
Press the VCR button, then press the TIMER button.
^SELECT A V CHOOSE WOK
VCR PLUS+
QUICK PROGRAMMING
PROGRAM REVIEW
.TO END PUSH EXIT
2
Press the PLAY A or STOP ▼ button to select QUICK
PROGRAMMING, then press the FF ►/OK button.
^ONETIME PROGRAM
PROGRAM I
CHANNEL +/--------------
START+/- AM
STOP+/- AM
REC SPEED SLP
DATE +/-
SET DAILY=8 ORWEEKLY=9
TO END PUSH EXIT
2
3
3
Press the CH(annel) A/T button to enter the channel you
want to record.
« If you are using a standard antenna or cable to VCR to TV
hookup (as shown on pages 6-7), enter the channel of the TV
program you want to record.
^ If you are using a Cable Box/DBS, enter the Cable Box/DBS out­
put channel (03 or 04). Set the Cable Box/DBS to the channel
you want to record and leave the Cable Box/DBS on for a timer
recording.
'O netime program
PROGRAM I
CHANNEL+/- 12
START+/-
AM
STOP+/- AM
REC SPEED SLP
DATE +/-
SET DAILY=8 ORWEEKLY=9
TO END PUSH EXIT