Vcr i, Rerecording (tape duplication) 41 – Philips VRA456AT User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Rerecording (Tape Duplication) 41
The instructions on this page show you how to copy tapes.The illustration uses two VRA656 VCRs.
Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow steps
1-6. (You may use the AUDIO and VIDEO In jacks on the front of VCR 2 instead if you prefer.)
VCR I
Playing VCR
VCR
2
3) Use an RF coaxial cable to connect the RF OUT
Recording VCR
on VCR 2 to the TV’s ANTENNA IN Jack.
I
VCR I will play your tape. Insert a prerecorded tape in VCR
I. If the tape does not have a record tab, playback begins. If this
happens, press the STOP/EJECT button on VCR I once.
2
VCR 2 will record your tape. Insert a blank tape in VCR 2.
Make sure the VCR power is on and the VCR is in VCR
position. (The VCR light will appear on the display panel. If it does
not, press the VCR/TV button once.)
3
Turn on the TV; set it to channel 3 or 4, whichever channel
the CHЗ/CF^4 switch on VCR 2 is set to.
Point the remote control at VCR 2. Press the VCR button,
then press the Number buttons 0,0. Press the CH(annel)
A/T
button so that AA/ IN FRONT or A/V IN REAR appears on
the screen.
5
Point the remote control at VCR 2. Press the SPEED but
ton to select SP or SLR
6
Press the PLAY button on VCR I and the REC(ord)/OTR
button on VCR 2 at the same time. The
O
light will appear
on the VCR 2 display panel.
Helpful Hints
Unauthorized recording of copyright
ed television programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws.
If a program has copy guard protec
tion, it may not record clearly.
Audio and video cables are not
included.
The VCR in the figure above is the
VRA656. If you have the VRA456,
use a single-plug (monaural) audio
cable to connect the AUDIO OUT
Jack on VCR I to the AUDIO IN Jack
on VCR 2.
To stop copying tapes, press the
STOPIEJECT button on VCR 2, then
press the STOP/EJECT button on
VCR I.
If you connect the audio and video
cables to the AUDIO/VIDEO In jacks
on the front of VCR 2, you must
select A/V IN FRONT at step 4. If
you connect the audio and video
cables to the AUDIO/VIDEO IN
Jacks on the back of VCR 2, you
must select A/V IN REAR at step 4.