Philips VRA456AT - Manual (Page 34)

Follow the steps below to program a timer recording using
PlusCode programming numbers. Before you begin make sure:
® Channels are set up.
Details are on pages 11-12.
^ The clock is set. Details are on pages 13-17.
® There is a tape in the VCR. Make sure the tape’s record tab is
intact and the tape is long enough to record the program(s).
® The VCR is in VCR position (the VCR light will appear on the
display panel). If the VCR light does not appear, press the
VCR/TV button once.
® You have programmed the VCR Plus+ and Cable/TV channel
numbers. Details are on pages 32-33.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may start again at step I.
34
Timer Recording with the VCR Plus* Programming System
1
*rc
2
Press the VCR button.
Press the TIMER button.
^SELECT ▲ ▼ CHOOSE >/OK
VCR PLUS+
QUICK PROGRAMMING
PROGRAM REVIEW
.TO END PUSH EXIT
3
Press the PLAY A or STOP ▼ button to select VCR
PLUS+, then press the FF ►/OK button.
^VCR PLUS+ PROG. CODE
VCR PLUS+
.TO END PUSH EXIT
4
Use the Number buttons to enter the PlusCode program­
ming number of the program you wish to record. (This
number is different for every program.)
VCR/TV POWER EJECT
o o ©
-------- QUICK PROGRAMMING -------
STW : STOP : date
fCZHCH
/VCR PLUS+ PROG. CODE
VCRPLUS+ I234B
TO SET PUSH >/OK
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
Helpful Hint
If you enter an incorrect PlusCode
programming number at step 4,
ERROR-RE-ENTER CODE will flash
on the screen after step
5. Enter the
correct PlusCode programming num­
ber.