Tuner, Manual programming, Storing radio stations – Philips FWR8R37 User Manual
Page 32: Tuning to preset stations, Automatic programming, Manual recording, Tuning to radio stations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TUNER
m
3
(Q_
w
Tuning to radio stations
1 Press TUNER to select the tuner.
-►Tuner
is scrolled.
2 Press TUNER again to select the desired waveband.
-►The selected waveband is displayed.
3 Keep ◄◄ SEARCEI or ►► SEARCEI or ►► on the remote
control) pressed for more than a half second.
-►The selected waveband and
Searching
are displayed.
The radio tunes to a station with sufficient signal strength.
4 Repeat searching until you find the desired station.
2 Keep PROG (PROGRAM on the remote control) pressed for
more than 2 seconds.
-►flutoprogram is displayed,
PROG
and the current
preset number in the music calendar start blinking.
-►All available radio stations for the selected waveband are
stored automatically,
prog
goes off, the preset number,
the waveband and the frequency of the last preset station
are displayed briefly.
• To store radio stations for another waveband, repeat steps
1-2. Make sure to select the next available preset number
first before proceeding, otherwise already programmed
radio stations may be erased.
• To exit the automatic programming, press PROG (PROGRAM
on the remote control).
Note: Strong stations will always automatically be programmed
first, followed by the weak stations.
Manual programming
1 Follow steps 1 and 2 of "Tuning to radio stations".
2 Keep PROG (PROGRAM on the remote control) pressed for
less than 2 seconds.
-►PROG
and the current preset number in the music
calendar start flashing.
3 Press ◄◄ SEARCEI or ►> SEARCEI (◄◄ or ►► on the remote
control) to tune to the desired radio station.
• To allocate the radio station to another preset number,
rotate N JOG CONTROL N (press N or N on the
remote control).
4 Press YES to confirm the setting,
-►PROG
goes off, the preset number, the waveband and
the frequency of the preset station are displayed.
• To tune to a weak station, briefly press ◄◄ SEARCEI or
►► SEARCH (◄◄ or ►► on the remote control) as often as
necessary for optimum reception.
Storing radio stations
It is possible to store up to 40 radio stations. Stations can be
selected and programmed automatically or you can do that
yourself. Programming will overwrite your former presets
starting from the last active preset station. After programming
the last stored preset station will be tuned.
To exit manual programming, press PROG (PROGRAM on
the remote control).
Tuning to preset stations
|
• Use M JOG CONTROL M ( N or N on the remote control)
until the preset number of the desired station is displayed.
Automatic programming
If no preset is tuned, automatic programming starts at preset
number one.
1 Follow steps 1 and 2 of "Tuning to radio stations".
26