Installation, Antenna connections, Speaker connections – Philips FWR8R37 User Manual
Page 14: Am antenna, Fm antenna
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
Power
Antenna connections
(/)
The type plate is located on the rear of the unit.
1 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does
not, consult your dealer or service organization.
2 Make sure all connections have been made before
switching on the power supply.
3
Connect the supplied power cable to AC MAINS ~ and to
the power outlet. This switches on the power supply.
For optimal performance use only the original power
cable.
When the unit is switched to standby, it is still consuming
some power. To disconnect the unit from the power
completely, remove the power cable from the power outlet.
To avoid overheating of the unit, a safety circuit has
been built in. Therefore, your unit may disconnect
under extreme conditions. If this happens, switch the
unit offend let it cool down before reusing it.
Speaker connections
The speaker connections are click-fit connectors. Use them as
shown below.
1 Connect the colored (or marked) wire to the red terminal
and the black (or unmarked) wire to the black terminal.
2
Connect:
- Left speaker to L (red and black)
- Right speaker to R (red and black)
AM antenna
The supplied loop antenna is for indoor use only.
1
Fit the plug of the loop antenna to AM AERIAL as shown
below.
2
Position the antenna as far as possible from a TV, VCR or
other radiation sources.
3
Turn the antenna for optimum reception.
FM antenna
The supplied wire antenna can only be used to receive nearby
stations. For better reception we recommend using a cable
antenna system or an outdoor antenna.
1 Open the FM AERIAL 300 il click-fits by pushing the lever
down as shown below.
2
Insert each wire of the antenna into one hole.
3
Close the click-fits using the lever.
4
Move the antenna in different positions for optimum
reception.
The unit complies with the FCC-Rules, Part 15 and with
21CFR 1040.10. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.