Compaq AP500 - Manual (Page 72)

3-52 Removal and Replacement Procedures
Installing the Battery
CAUTION: Static electricity can damage the electronic components of the
workstation. Before beginning these procedures, make sure you are properly
grounded. See “Electrostatic Discharge Information” in Chapter 2 for more
information.
To install an external real-time clock battery:
1. Perform the service preparations shown on page 3-2, then lay the workstation on its side.
2. Remove the following components:
❏ Workstation feet
❏ Side access panel
❏ I/O bracket assembly
3. Remove the backing from the adhesive on the hook-and-loop fastener strip and attach the
battery near the J5 jumper.
4. Connect the battery connector to pins 1 - 4 on J5 1 and move the jumper from pins 6 and
7 to pins 5 and 6 2.
2
1
1
1
Figure 3-49. Installing the replacement battery