Compaq AP500 - Manual (Page 28)

3-8 Removal and Replacement Procedures
EMI/Cooling Shield
An EMI/cooling shield covers bays 5 and 6 to provide proper cooling and EMI protection.
To remove an EMI/cooling shield:
1. Perform the service preparations shown on page 3-2.
2. Remove the following components:
❏ Side access panel
❏ Front bezel
3. Remove the two screws that connect the EMI/cooling shield to the drive cage.
4. Remove the EMI/cooling shield from the drive slot.
COMPACT
Figure 3-7. Removing the EMI/cooling shield
To replace the EMI/cooling shield, reverse the above procedure.
IMPORTANT: You must replace the shield after a hard drive is installed in the bay.