Compaq AP500 User Manual
Page 64
3-44
Removal and Replacement Procedures
To install a new system board with tray and cage:
1.
Remove the following components from the system board with tray:
❏
DIMMs
❏
Processor(s)
❏
Processor power module(s)
❏
External battery (if installed)
2.
Install the components on the new system board with tray. Before reinstalling the
DIMMs, see “Important Guidelines for DIMM Installation” earlier in this chapter.
3.
Slide the new system board with tray into the chassis.
4.
Connect all cables to the system board.
5.
Replace the I/O bracket assembly, the side access panel, and the workstation feet.