Compaq AP500 User Manual
Page 59
3-39
Compaq Professional Workstation AP500 Maintenance and Service Guide
Installing a Hard Drive in the Removable Hard Drive Cage
To install a hard drive in the removable hard drive cage:
1.
Perform the service preparations shown on page 3-2, then lay the workstation on its side.
2.
Remove the following components:
❏
Workstation feet
❏
Side access panel
❏
Removable hard drive cage
3.
Remove the hard drive screws (top group of screws) from the side of the air plenum
located at the front of the workstation.
4
3
2
1
Figure 3-38. Locating the removable hard drive screw holes
Table 3-3
Removable Hard Drive Screw Holes
Reference
Bay
4
Bay 3: 1.0-inch drive
3
Bay 3: 1.6-inch drive
2
Bay 2: 1.0-inch drive
1
Bay 1: 1.0-inch drive
4.
Insert the hard drive into the removable hard drive cage, and secure the drive with the four
hard drive screws. (See the above illustration and table for the location of the correct screw
holes for the hard drive you are installing.)