Compaq AP500 - Manual (Page 23)

3-3
Compaq Professional Workstation AP500 Maintenance and Service Guide
Cable Lock
The workstation comes standard with a cable lock provision for attaching a padlock and/or cable
lock. If installed, the locks must be removed before accessing internal components.
To remove the lock:
1. Unlock and remove the cable lock and/or the padlock 1.
2. Remove the security bracket (plate) seated over the cable lock bracket 2.
3. Unfasten the retaining screw to release the cable lock bracket 3.
1
2
3
Figure 3-2. Removing the padlock
NOTE: In some of the removal procedures in this chapter, you will be asked to remove the
workstation feet and lay the workstation on its side when servicing some of the internal
components.
NOTE: For more information on preparing the workstation for service, see Chapter 2.