KGUARD Security OT1601 - Manual (Page 63)

ENGLISH
Chapter 5: KGUARD Web Client
DVR User’s Manual
63
Chapter 5: KGUARD Web Client
Use KGUARD Web Client to remotely access the DVR at anytime.
To access KGUARD Web Client you must ensure the following requirements are met:
• The Network settings of the DVR is properly configured. See “4.4 Setting the Network” on page 43 .
• Your computer has a web browser, such as Internet Explorer or Safari, installed.
5.1 Login
KGUARD Web Client allows up to 3 simultaneous access. However, only one administrator account is allowed per
access.
1
Open your computer web browser and enter the DVR IP address or domain name in the URL box.
For example, see illustration below:
Don’t know the IP Address of your DVR?
The IP address of the DVR vary depending on the network settings you configured in NETWORK menu (see “4.4
Setting the Network” on page 43 ).
• If your network type is DHCP, ask your network administrator for the IP address assigned to the DVR.
• If your network type is PPPoE, ask your Internet Service Provider (ISP) for the IP address assigned to the DVR.
• If your network type is Static IP, check the IP address you configured for IP ADDR in NETWORK menu.
• If the DVR is connected to a DDNS, check the Domain Name that you configured when you created the DDNS
account and type the domain name in the URL box.
Note:
For MAC users, you may be prompted to install necessary plug-ins to access the KGUARD Web Client. Follow the
on-screen instructions to complete the installation. When prompted for password entry, leave the password empty
and select Install.
2
Enter the User Name and Password.
Note:
The default administrator User Name is “admin” and the password
is empty. To change the password, see
“Changing the Password” on page 55 .
3
If necessary, modify the Client Port, this should be the same port as configured in the Network Settings menu.
4
On Quality, select Record setup or Remote stream.
5
Click Login.