Juniper Systems Allegro DAQ User Manual
Data acquisition expansion pod, User’s guide
Table of contents
Document Outline
- Chapter 1: Introduction
- Physical Description
- Chapter 2: Before Connecting the Data Acquisition Expansion Pod
- Chapter 3: Connecting the Expansion Pod
- Chapter 4: Finding More Information
- Chapter 5: Signal Descriptions
- Chapter 6: Configuration Switches
- Default Switch Settings
- Configuring Switches
- Continuously enable the Sensor Excitation Output
- Use DIO7 to enable/disable Sensor Excitation Output
- Bypass the Sensor Excitation (Output Analog Out 0 rather than the Sensor Excitation)
- Enable current limit monitoring
- Disable current limit monitoring and reconnect the PFI5 signal to the 50-pin connector
- Locating Switches on the Schematic
- Appendix: DAQ Expansion Pod Schematic