Philips CCX193AT - Manual (Page 8)

8 Turning On the TYIVCR
Before you turn on theTV/VCR, make sure there are batteries in
the remote control (details are on page five) and theTV/VCR is
hooked up correctly (details are on pages six - seven).
The instructions on this page work only when you turn on the
TV/VCR for the first time.
Press the POWER button. The TV/VCR will come on and the
language select display screen shown below will appear.
SELECT LANGUAGE ^
t ENGUSH ON
2 ESPAÑOL
MAKE SELECTION OR
PRESS EXITTO CONTINUE
Press the Number i button to select English on-screen
displays or press the Number 2 button to select Spanish
on-screen displays.
Press the STATUS/EXIT button. The channel program display
screen shown below will appear.
/OCMVECTANTB^ORCAEIE^
TOTVCR
THEN PRESS+
TO END PRESS EXIT
Press the F.FWD/+ button to begin automatic channel
programming. AUTO SET PROCEEDING / PLEASE WAIT will
appear on-screen. TheTV/VCR will place all of the channels you
receive into its memory, so when you scan dirough channels using
the CHANNEL Up/Down buttons, you’ll only scan through chan­
nels that you receive.When channels are programmed, CHAN­
NELS ARE SET will appear on-screen briefly.Then theTV/VCR will
go to the lowest channel programmed,
(If you try to program channels when there is no antenna or cable
connected to theTV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on-screen.
Connect an antenna or cable to the TV/VCR, then try again.You
may need to follow the steps on pages nine - 11 instead.)
Now, you may use the CHANNEL Up/Down buttons or the
Number buttons on the remote control to select aTV/VCR chan­
nel. Use the VOLUME Up/Down buttons to adjust the sound.
o
o
q j C p Q S
Fyi'om Er*T%ar p£.Tru vcafvp* oo oo
0 ^ 0 0
PHILtPS
Helpful Hints
If you do not see any on-screen dis­
plays when you turn on the TV/VCR,
check your hook-ups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine - 11 to select a language and
program channels.
To skip this feoiure and play a tape
immediately, insert a tape with its
record tab removed. Playback will
begin. Or, to sidp step 2, press the
STATUS/EXIT button be/bre pro­
ceeding. All on-screen d/sp/ays will be
in English.To skip step 4, press the
STATUS/EXIT button before pro­
ceeding. Channels will not be pro­
grammed, and CHANNELS NOT
SET will appear on-screen briefly.
You cannot program channels if you
are using a Cable Box.
Line input mode will always be
stored in the TV/VCR’s memory as
channel 00. When you se/ect chan­
nel 00,A/V IN will appear on-screen
briefly. Press the CHANNEL
Up/Down buttons or Number but­
tons to select another channel.